Left front brake hose assembly左前制动软管总成

Removal procedure拆卸程序

1. Preparation1. 准备工作 1 Drive the vehicle into the lift position, activate the parking brake, and put the vehicle power supply in the "OFF" state.将车辆驶入举升机举升位置，启用驻车制动，整车电源处于“OFF”状态。 2 Lift the vehicle.举升车辆。

2. Remove the left front wheel assembly2. 拆卸左前车轮总成 Reference: Wheel assembly参考：车轮总成

3. Remove the left front brake hose assembly3. 拆卸左前制动软管总成

1 Remove the fixing bolt ③, hollow bolt ②, and oil pipe joint nut ①, take out the fixing clip A, and remove the left front brake hose assembly B.拆卸固定螺栓③、空心螺栓②、油管接头螺母①，取出固定夹片A，取下左前制动软管总成B。 Recommended tools: 10mm socket ③, 11mm socket ②, 10mm tubing wrench ①, carp pliers推荐工具：10mm套筒③、11mm套筒②、10mm油管扳手①、鲤鱼钳

Installation procedure安装程序

1. Install the left front brake hose assembly1. 安装左前制动软管总成

1 Place and adjust the left front brake hose assembly B to the installation position, install the fixing clip A, install the oil pipe joint nut ①, hollow bolt ②, and fixing bolt ③ and tighten them.放置并调整左前制动软管总成B到安装位置，安装固定夹片A，安装油管接头螺母①、空心螺栓②、固定螺栓③并紧固。 Recommended tools: 10mm socket ③, 11mm socket ②, 10mm tubing wrench ①, carp pliers推荐工具：10mm套筒③、11mm套筒②、10mm油管扳手①、鲤鱼钳 Torque requirements: 15-19N·m①, 24-30N·m②, 6-10N·m③扭矩要求：15-19N•m①、24-30N•m②、6-10N•m③   Caution:注意： ♦  Avoid missing the copper gaskets at both ends of the hollow bolts.避免漏安装空心螺栓两端铜垫片。 ♦  The copper gasket is a disposable piece and needs to be replaced.铜垫片为一次性件，需更换。

2. Add brake fluid and bleed the brake system2. 加注制动液并对制动系统排气 Reference: brake fluid参考：制动液

3. Install the left front wheel assembly3. 安装左前车轮总成 Reference: Wheel assembly参考：车轮总成

4. Land the vehicle, start the vehicle and drive off the lift, and conduct a road test to check the vehicle4. 降落车辆，起动车辆并驶离举升机，路试检查车辆