Twist beam left mounting bracket

1 Drive the vehicle into the lift position, activate the parking brake, and put the vehicle power supply in the "OFF" state.将车辆驶入举升机举升位置，启用驻车制动，整车电源处于“OFF”状态。

2 Lift the vehicle.举升车辆。

1 Use hydraulic bracket A to lift the torsion beam assembly.使用液压托架A托举扭梁总成。

2 Remove the fixing nuts and bolts ① and 4 fixing bolts ②, and take out the left mounting bracket A of the torsion beam.拆卸固定螺母及螺栓①、4颗固定螺栓②，取出扭梁左安装支架A。

1 Install the left mounting bracket A of the torsion beam onto the torsion beam assembly, install the fixing bolts and nuts ① and pre-tighten them.安装扭梁左安装支架A到扭梁总成上，安装固定螺栓及螺母①并预紧。

2 Raise the hydraulic bracket, place and adjust the left mounting bracket of the torsion beam to the installation position, install 4 fixing bolts ② and tighten them, and tighten the connecting bolts ① between the torsion beam assembly and the left mounting bracket of the torsion beam.升起液压托架，放置并调整扭梁左安装支架到安装位置，安装4颗固定螺栓②并紧固，紧固扭梁总成与扭梁左安装支架的连接螺栓①。

3 Land slowly and remove hydraulic bracket A.缓慢降落并移出液压托架A。