Lane departure warning ECU车道偏离预警ECU

Removal procedure拆卸程序

1. Preparation1. 准备工作 1 Park the vehicle on a flat road, activate the parking brake, and put the vehicle's power supply in the "OFF" state.将车辆停在平坦路面，启用驻车制动，使整车电源处于“OFF”状态。 2 Disconnect the negative terminal of the 12V battery.断开蓄电池负极。

2. Remove the decorative cover on the interior mirror2. 拆卸内视镜上装饰盖 Reference: Interior mirror upper decorative cover参考：内视镜上装饰盖

3. Remove the decorative cover under the endoscope3. 拆卸内视镜下装饰盖 Reference: Decorative cover under endoscope参考：内视镜下装饰盖

4. Disassemble the lane departure warning ECU4. 拆卸车道偏离预警ECU

1 Disconnect connector A, pry open the claws B on both sides of the lane departure warning ECU, and take out the lane departure warning ECU.断开接插件A，撬开车道偏离预警ECU两侧卡爪B，取出车道偏离预警ECU。 Recommended tools: clip remover推荐工具：卡扣起子

Installation procedure安装程序

1. Install lane departure warning ECU1. 安装车道偏离预警ECU

1 Place and adjust the lane departure warning ECU to the installation position, install the claws B on both sides, and connect the connector A.放置并调整车道偏离预警ECU到安装位置，安装两侧卡爪B，连接接插件A。

2. Install the decorative cover under the interior mirror2. 安装内饰镜下装饰盖 Reference: Decorative cover under endoscope参考：内视镜下装饰盖

3. Install the decorative cover on the interior mirror3. 安装内饰镜上装饰盖 Reference: Interior mirror upper decorative cover参考：内视镜上装饰盖

4. Connect the negative terminal of the 12V battery, start the vehicle, and check that the lane departure warning ECU should work normally.4. 连接蓄电池负极，启动车辆，检查车道偏离预警ECU应正常工作