B1ED44B - TroubleshootingB1ED44B-故障诊断

Fault code description故障码说明

DTC故障码(DTC)	Fault code description故障码描述	Possible cause of failure可能故障原因
B1ED44B	There is a fault in the angle radar system and the temperature is too high角雷达系统存在故障，温度过高	1.Radar overheating failure1.雷达过热故障

Troubleshooting steps故障诊断步骤

①General inspection一般检查

1. Check for unusual heat sources around the vehicle.检查车辆周围是否存在异常热源。 2. Check whether the ambient temperature of the vehicle is too high.检查车辆所处环境温度是否过高。 Are the test results normal?检查结果是否正常？ Yes是 Go to step 2.去步骤2。 No否 Move the vehicle away from the current environment.将车辆驶离当前环境。

②Cooling check冷却检查

1. Turn off the power to the entire vehicle and let the vehicle sit for a while to cool down.关闭整车电源，将车辆静置冷却一段时间。 2. Power on again and check whether the fault code and symptoms are eliminated.重新上电，检查故障码及症状是否排除。 Are the test results normal?检查结果是否正常？ Yes是 Fault resolved.故障排除。 No否 Go to step 3.去步骤3。

③Replace the left front blind spot monitoring main sensor更换左前盲区监测主传感器

1. Replace with a new left front blind spot monitoring main sensor and check whether the fault code and symptoms are eliminated.更换新的左前盲区监测主传感器，检查故障码及症状是否排除。 Are the test results normal?检查结果是否正常？ Yes是 Fault resolved.故障排除。 No否 Look for causes from other symptoms.从其他症状查找原因。   Caution:注意： ♦  After replacing the main sensor for monitoring the left front blind spot, you need to use a diagnostic instrument to recalibrate the main sensor for monitoring the left front blind spot.更换左前盲区监测主传感器后，需用诊断仪对左前盲区监测主传感器重新标定。