P229287 - TroubleshootingP229287-故障诊断

Fault code description故障码说明

DTC故障码(DTC)	Fault code description故障码描述	Possible cause of failure可能故障原因
P229287	PFC loses internal CAN communicationPFC丢失内CAN通讯	1.DSP software failure1.DSP软件失效
		2. Poor contact of communication connecting devices2.通讯连接器件接触不良
		3. There is electromagnetic interference3.存在电磁干扰

Troubleshooting steps故障诊断步骤

①General inspection一般检查

1. Check whether the CAN communication harness is damaged or broken.检查CAN通讯线束是否存在损坏、断裂等现象。 2. Check the CAN communication harness connector for loose connections or damage.检查CAN通讯线束接插件是否存在虚接、损坏等现象。 Are the test results normal?检查结果是否正常？ Yes是 Go to step 2.去步骤2。 No否 Repair or replace the CAN communication harness or connector.维修或更换CAN通讯线束或接插件。

②Power on check上电检查

1. Power on the vehicle again and check whether the fault code and symptoms are eliminated.车辆重新上电，检查故障码及症状是否排除。 Are the test results normal?检查结果是否正常？ Yes是 Fault resolved.故障排除。 No否 Go to step 3.去步骤3。

③Check for electromagnetic interference检查电磁干扰

1. Check for sources of magnetic fields around the vehicle.检查车辆周围是否存在磁场源。 Are the test results normal?检查结果是否正常？ Yes是 Go to step 4.去步骤4。 No否 Move the vehicle away from its current environment.使车辆驶离当前环境。

④Replacing the integrated electric drive assembly更换集成电力驱动总成

1. Replace the integrated electric drive assembly with a new one and check whether the fault code and symptoms are eliminated.更换新的集成电力驱动总成，检查故障码及症状是否排除。 Are the test results normal?检查结果是否正常？ Yes是 Fault resolved.故障排除。 No否 Look for causes from other symptoms.从其他症状查找原因。   Caution:注意： ♦  After replacing the integrated electric drive assembly, you need to use a diagnostic tool to recalibrate the integrated electric drive assembly.更换集成电力驱动总成后，需用诊断仪对集成电力驱动总成重新标定。