Smart Bluetooth module智能蓝牙模块

Removal procedure拆卸程序

1. Preparation1. 准备工作 1 Park the vehicle on a flat road, activate the parking brake, and put the vehicle's power supply in the "OFF" state.将车辆停在平坦路面，启用驻车制动，使整车电源处于“OFF”状态。 2 Disconnect the negative terminal of the 12V battery.断开蓄电池负极。

2. Remove the decorative cover on the interior mirror2. 拆卸内视镜上装饰盖 Reference: Interior mirror upper decorative cover参考：内视镜上装饰盖

3. Remove the decorative cover under the endoscope3. 拆卸内视镜下装饰盖 Reference: Decorative cover under endoscope参考：内视镜下装饰盖

4. Remove the smart Bluetooth module4. 拆卸智能蓝牙模块

1 Disconnect connector A, remove the 3 fixing screws ①, and remove the smart Bluetooth module.断开接插件A，拆卸3颗固定螺钉①，取下智能蓝牙模块。 Recommended tools: Phillips screwdriver推荐工具：十字螺丝刀

Installation procedure安装程序

1. Install the smart Bluetooth module1. 安装智能蓝牙模块

1 Place and adjust the smart Bluetooth module to the installation position, install and tighten the 3 fixing screws ①, and connect connector A.放置并调整智能蓝牙模块到安装位置，安装3颗固定螺钉①并紧固，连接接插件A。 Recommended tools: Phillips screwdriver推荐工具：十字螺丝刀

2. Install the decorative cover under the endoscope2. 安装内视镜下装饰盖 Reference: Decorative cover under endoscope参考：内视镜下装饰盖

3. Install the decorative cover on the interior mirror3. 安装内视镜上装饰盖 Reference: Interior mirror upper decorative cover参考：内视镜上装饰盖

4. Connect the negative terminal of the 12V battery, start the vehicle, and check that the smart Bluetooth module should work normally.4. 连接蓄电池负极，启动车辆，检查智能蓝牙模块应正常工作