Rain light sensor雨量光线传感器
Removal procedure拆卸程序
|
1. Preparation1. 准备工作
1 Park the vehicle on a flat road, activate the parking brake, and put the vehicle's power supply in the "OFF" state.将车辆停在平坦路面，启用驻车制动，使整车电源处于“OFF”状态。
2 Disconnect the negative terminal of the 12V battery.断开蓄电池负极。
|
|
2. Remove the decorative cover on the interior mirror2. 拆卸内视镜上装饰盖
|
|
3. Remove the decorative cover under the endoscope3. 拆卸内视镜下装饰盖
|
|
4. Remove the rain light sensor4. 拆卸雨量光线传感器
|
 |
1 Disconnect connector A, pry open the claws on both sides of the rain and light sensor, and take out the rain and light sensor.断开接插件A，撬开雨量光线传感器两侧卡爪，取出雨量光线传感器。
|
Installation procedure安装程序
|
1. Install the rain light sensor1. 安装雨量光线传感器
|
|
|
1 Place and adjust the rain light sensor to the installation position and connect connector A.放置并调整雨量光线传感器到安装位置，连接接插件A。
|
|
2. Install the decorative cover under the endoscope2. 安装内视镜下装饰盖
|
|
3. Install the decorative cover on the interior mirror3. 安装内视镜上装饰盖
|
|
4. Connect the negative terminal of the 12V battery, start the vehicle, and check that the rain light sensor should work normally.4. 连接蓄电池负极，启动车辆，检查雨量光线传感器应正常工作
|