Front protection millimeter wave radar assembly前保毫米波雷达总成

Removal procedure拆卸程序

1. Preparation1. 准备工作 1 Park the vehicle on a flat road, activate the parking brake, and keep the vehicle power supply in "OFF" state.将车辆停在平坦路面，启用驻车制动，使整 车电源处于“OFF”状态。 2 Disconnect the negative terminal of the 12V battery.断开蓄电池负极。

2. Disassemble the front millimeter wave radar assembly2. 拆卸前保毫米波雷达总成

1 Pry out the forward radar bracket A.撬出前向雷达支架A。 Recommended tools: Interior parts removal tools推荐工具：内饰件拆卸工具   Note:提示： ♦  Pay attention to the 4 clip locations in the picture.注意图示4处卡子位置。

2 Pull the three upper and lower cards ① to both sides and take out the front millimeter wave radar assembly.向两侧扳动上下3个卡①，取出前保毫米波雷达总成。 Recommended tools: clip remover推荐工具：卡扣起子 3 Disconnect connector A and remove the front millimeter wave radar assembly.断开接插件A，取下前保毫米波雷达总成。

Installation procedure安装程序

1. Install the front protection millimeter wave radar assembly1. 安装前保毫米波雷达总成 1 Connect connector A to the front millimeter wave radar assembly.连接接插件A到前保毫米波雷达总成。

2 Place and adjust the front millimeter-wave radar assembly to the installation position, pull the upper and lower three side cards ①, press hard and tighten.放置并调整前保毫米波雷达总成到安装位置，扳动上下三侧卡①，用力按压并扣紧。

3 Place and adjust the forward radar bracket A to the installation position, press firmly and fasten it.放置并调整前向雷达支架A到安装位置，用力按压并扣紧。

2. Connect the negative terminal of the 12V battery, start the vehicle, and check that the front millimeter wave radar assembly should be working normally.2. 连接蓄电池负极，起动车辆，检查前保毫米波雷达总成应正常工作