|
①General inspection一般检查
|
|
1. |
Power state is "OFF", disconnect the negative terminal of the 12V battery.电源状态“OFF”,断开蓄电池负极。
|
|
2. |
Check the left front door midrange speaker and left front tweeter wire harness for damage, breakage, etc.检查左前门中音扬声器与左前高音扬声器线束是否存在损坏、断裂等现象。
|
|
3. |
Check the left front door midrange speaker and left front tweeter harness connectors for loose connections or damage.检查左前门中音扬声器与左前高音扬声器线束接插件是否存在虚接、损坏等现象。
|
Are the test results normal?检查结果是否正常?
|
No否 |
Repair or replace faulty wiring harness or connector.维修或更换故障线束或接插件。 |
|
|
②Check the wiring harness between the car's infotainment head unit and the left front speaker检查车载智能多媒体主机至左前扬声器之间的线束
|
 |
|
1. |
Power state is "OFF", disconnect the negative terminal of the 12V battery.电源状态“OFF”,断开蓄电池负极。
|
|
2. |
Disconnect the vehicle infotainment head unit harness connector IP48, the left front door midrange speaker harness connector FL10, and the left front tweeter harness connector BD49.断开车载智能多媒体主机线束接插件IP48和左前门中音扬声器线束接插件FL10、左前高音扬声器线束接插件BD49。
|
|
3. |
Connect the negative terminal of the 12V battery and the power status is "ON".连接蓄电池负极,电源状态“ON”。 |
|
4. |
Use a digital multimeter to measure the voltage between pin 1/5 of the IP48 and ground.用数字万用表测量IP48的1/5号针脚与接地之间的电压。 Standard voltage value: 0V标准电压值:0V
|
Are the test results normal?检查结果是否正常?
|
No否 |
Repair or replace the wiring harness between the vehicle's infotainment head unit and the left front speaker.维修或更换车载智能多媒体主机至左前扬声器之间的线束。 |
|
|
③Replace left front door midrange speaker更换左前门中音扬声器
|
|
1. |
Replace the left front door mid-range speaker with a new one and check whether the fault code and symptoms are eliminated.更换新的左前门中音扬声器,检查故障码及症状是否排除。
|
Are the test results normal?检查结果是否正常?
|
Yes是 |
Fault resolved.故障排除。 |
|
|
④Replace left front tweeter更换左前高音扬声器
|
|
1. |
Replace the front left tweeter with a new one and check whether the fault code and symptoms are eliminated.更换新的左前高音扬声器,检查故障码及症状是否排除。
|
Are the test results normal?检查结果是否正常?
|
Yes是 |
Fault resolved.故障排除。 |
|
|
⑤Replacement of infotainment head unit更换车载智能多媒体主机
|
|
1. |
Replace with a new infotainment head unit and check whether the fault code and symptoms are eliminated.更换新的车载智能多媒体主机,检查故障码及症状是否排除。
|
Are the test results normal?检查结果是否正常?
|
Yes是 |
Fault resolved.故障排除。 |
|
No否 |
Look for causes from other symptoms.从其他症状查找原因。 |
Caution:注意: |
|
♦
|
After replacing the infotainment head unit, it is necessary to use a diagnostic instrument to recalibrate the infotainment head unit.更换车载智能多媒体主机后,需用诊断仪对车载智能多媒体主机重新标定。 |
|
|