|
①General inspection一般检查
|
|
1. |
Power state is "OFF", disconnect the negative terminal of the 12V battery.电源状态“OFF”,断开蓄电池负极。
|
|
2. |
Check the left rear microphone harness for damage, breakage, etc.检查左后麦克风线束是否存在损坏、断裂等现象。
|
|
3. |
Check whether there is any loose connection or damage to the left rear microphone harness connector.检查左后麦克风线束接插件是否存在虚接、损坏等现象。
|
Are the test results normal?检查结果是否正常?
|
No否 |
Repair or replace faulty wiring harness or connector.维修或更换故障线束或接插件。 |
|
|
②Check the second row left rear MIC signal line检查二排左后MIC信号线路
|
 |
|
1. |
Power state is "OFF", disconnect the negative terminal of the 12V battery.电源状态“OFF”,断开蓄电池负极。
|
|
2. |
Disconnect the left rear microphone harness connector BD102 and the vehicle infotainment head unit harness connector IP55.断开左后麦克风线束接插件BD102和车载智能多媒体主机线束接插件IP55。
|
|
3. |
Use a digital multimeter to measure the resistance between pin 31 of the IP55 and ground.用数字万用表测量IP55的31号针脚与接地之间的电阻。
Standard resistance value: >1M标准电阻值:>1M
Ω
|
Are the test results normal?检查结果是否正常?
|
No否 |
Repair or replace the second row left rear MIC signal harness.维修或更换二排左后MIC信号线束。 |
|
|
③Replace left rear microphone更换左后麦克风
|
|
1. |
Replace the left rear microphone with a new one and check whether the fault code and symptoms are eliminated.更换新的左后麦克风,检查故障码及症状是否排除。
|
Are the test results normal?检查结果是否正常?
|
Yes是 |
Fault resolved.故障排除。 |
|
|
④Replacement of infotainment head unit更换车载智能多媒体主机
|
|
1. |
Replace with a new infotainment head unit and check whether the fault code and symptoms are eliminated.更换新的车载智能多媒体主机,检查故障码及症状是否排除。
|
Are the test results normal?检查结果是否正常?
|
Yes是 |
Fault resolved.故障排除。 |
|
No否 |
Look for causes from other symptoms.从其他症状查找原因。 |
Caution:注意: |
|
♦
|
After replacing the infotainment head unit, it is necessary to use a diagnostic instrument to recalibrate the infotainment head unit.更换车载智能多媒体主机后,需用诊断仪对车载智能多媒体主机重新标定。 |
|
|