ETC vehicle-mounted unitETC车载单元

Removal procedure拆卸程序

1. Preparation1. 准备工作 1 Park the vehicle on a flat road, activate the parking brake, and put the vehicle's power supply in the "OFF" state.将车辆停在平坦路面，启用驻车制动，使整车电源处于“OFF”状态。 2 Disconnect the negative terminal of the 12V battery.断开蓄电池负极。

2. Disassemble the ETC vehicle-mounted unit2. 拆卸ETC车载单元

1 Pry out the wiring harness of ETC vehicle unit A, disconnect connector B, and clean up the remaining double-sided tape.撬出ETC车载单元A带线束，断开接插件B，并清理残余双面胶。 Recommended tools: Interior parts removal tools推荐工具：内饰件拆卸工具   Caution:注意： ♦  Clean and dry the pasting surface before installation.安装前先对粘贴表面进行清洁并干燥。

Installation procedure安装程序

1. Install ETC on-board unit1. 安装ETC车载单元

1 Connect connector B, place and adjust ETC vehicle unit A to the installation position.连接接插件B，放置并调整ETC车载单元A到安装位置。   Caution:注意： ♦  After replacing the ETC vehicle-mounted unit, the ETC vehicle-mounted unit needs to be reactivated before it can be used normally.更换ETC车载单元后，需对ETC车载单元重新激活才能正常使用。

2. Connect the negative terminal of the 12V battery, start the vehicle, and check that the ETC on-board unit should work normally2. 连接蓄电池负极，启动车辆，检查ETC车载单元应正常工作