Charging port assembly · GAC Aion V repair manual

Note:提示：

♦

The charging port assembly is a disposable part, please use new parts when installing.充电口总成为一次性部件，安装时请使用新部件。

1. Preparation1. 准备工作

1 Park the vehicle on a flat road, activate the parking brake, and put the vehicle's power supply in the "OFF" state.将车辆停在平坦路面，启用驻车制动，使整车电源处于“OFF”状态。

2 Disconnect the negative terminal of the 12V battery.断开蓄电池负极。

2. Remove the charging port assembly2. 拆卸充电口总成

1 Open the charging port cover, use a flat-blade screwdriver to insert the claw mark in the picture and pry out the charging port assembly with wire harness.打开充电口盖，使用一字螺丝刀插入图示卡爪标识位置撬出充电口总成带线束。

Recommended tools: Slotted screwdriver, interior parts removal tool推荐工具：一字螺丝刀、内饰件拆卸工具

Note:提示：

♦

Pay attention to the 4 fixing claws in the picture.注意图示4处固定卡爪。

Caution:注意：

♦

Avoid damaging the wiring harness by forcefully pulling off the charging port assembly.避免因用力扯下充电口总成而损坏线束。

2 Disconnect the charging port assembly connector and remove the charging port assembly.断开充电口总成接插件，取下充电口总成。

1. Install the charging port assembly1. 安装充电口总成

1 Connect the connector to the charging port assembly.连接接插件到充电口总成。

2 Place and adjust the charging port assembly to the installation position, align the fixing claw position in Figure 4 and press firmly to ensure that it is installed in place.放置并调整充电口总成到安装位置，对准图4处固定卡爪位置用力按压，确保安装到位。

2. Connect the negative terminal of the 12V battery2. 连接蓄电池负极

Charging port assembly充电口总成