C202829 - TroubleshootingC202829-故障诊断

Fault code description故障码说明

DTC故障码(DTC)	Fault code description故障码描述	Possible cause of failure可能故障原因
C202829	iTPMS left rear wheel speed signal is not availableiTPMS左后车轮转速信号不可用	1.iTPMS left rear wheel speed signal is not available1.iTPMS左后车轮转速信号不可用

Troubleshooting steps故障诊断步骤

①Power on check上电检查

1. Repower the vehicle, use the diagnostic tool to read and clear the fault codes, and check whether the fault codes and symptoms are eliminated.车辆重新上电，使用诊断仪读取并清除故障码，检查故障码及症状是否排除。 Are the test results normal?检查结果是否正常？ Yes是 Fault resolved.故障排除。 No否 Go to step 2.去步骤2。

②Check the left rear in-line wheel speed sensor fault code检查左后直插式轮速传感器故障码

1. Check whether there is a fault code related to the left rear in-line wheel speed sensor.检查是否存在左后直插式轮速传感器相关故障码。 Are the test results normal?检查结果是否正常？ Yes是 Go to step 3.去步骤3。 No否 Troubleshoot according to the fault code.根据故障码排除故障。

③Replacing the integrated brake control unit更换集成式制动控制单元

1. Replace with a new integrated brake control unit and check whether the fault code and symptoms are eliminated.更换新的集成式制动控制单元，检查故障码及症状是否排除。 Are the test results normal?检查结果是否正常？ Yes是 Fault resolved.故障排除。 No否 Look for causes from other symptoms.从其他症状查找原因。   Caution:注意： ♦  After replacing the integrated brake control unit, you need to use a diagnostic tool to recalibrate the integrated brake control unit.更换集成式制动控制单元后，需用诊断仪对集成式制动控制单元重新标定。 ♦  After replacing the integrated brake control unit, the brake line bleeding operation is required.更换集成式制动控制单元后，需进行制动管路排气操作。