P180E17 - TroubleshootingP180E17-故障诊断

Fault code description故障码说明

DTC故障码(DTC)	Fault code description故障码描述	Possible cause of failure可能故障原因
P180E17	Resolver power supply overvoltage fault旋变电源过压故障	1. The LVPS1 circuit itself is faulty1.LVPS1电路自身故障
		2.RDC_P power supply voltage sampling circuit failure2.RDC_P电源电压采样电路故障
		3. EN_LVPS enable signal failure3.EN_LVPS使能信号故障
		4.EN_LVPS_1 enable signal failure4.EN_LVPS_1使能信号故障
		5.LVPS1 output terminal failure5.LVPS1输出端故障

Troubleshooting steps故障诊断步骤

①Power on check上电检查

Repower the vehicle, use the diagnostic tool to read and clear the fault codes, and check whether the fault codes and symptoms are eliminated.车辆重新上电，使用诊断仪读取并清除故障码，检查故障码及症状是否排除。

Are the test results normal?检查结果是否正常？

Yes是

Fault resolved.故障排除。

No否

Go to step 2.去步骤2。

②Replacing the integrated electric drive assembly更换集成电力驱动总成

Replace the integrated electric drive assembly with a new one and check whether the fault code and symptoms are eliminated.更换新的集成电力驱动总成，检查故障码及症状是否排除。

Are the test results normal?检查结果是否正常？

Yes是

Fault resolved.故障排除。

No否

Look for causes from other symptoms.从其他症状查找原因。

Caution:注意：

♦

After replacing the integrated electric drive assembly, you need to use a diagnostic tool to recalibrate the integrated electric drive assembly.更换集成电力驱动总成后，需用诊断仪对集成电力驱动总成重新标定。