P189585 - TroubleshootingP189585-故障诊断

Fault code description故障码说明

DTC故障码(DTC)	Fault code description故障码描述	Possible cause of failure可能故障原因
P189585	Level-2 estimated torque and target torque are too largeLevel-2估算转矩与目标转矩偏大	1. Motor parameter error1.电机参数错误
		2. Voltage/current/motor rotor position detection error2.电压/电流/电机转子位置检测错误
		3. PWM wave execution failure3.PWM发波执行故障

Troubleshooting steps故障诊断步骤

①Power on check上电检查

Repower the vehicle, use the diagnostic tool to read and clear the fault codes, and check whether the fault codes and symptoms are eliminated.车辆重新上电，使用诊断仪读取并清除故障码，检查故障码及症状是否排除。

Are the test results normal?检查结果是否正常？

Yes是

Fault resolved.故障排除。

No否

Go to step 2.去步骤2。

②Replacing the integrated electric drive assembly更换集成电力驱动总成

Replace the integrated electric drive assembly with a new one and check whether the fault code and symptoms are eliminated.更换新的集成电力驱动总成，检查故障码及症状是否排除。

Are the test results normal?检查结果是否正常？

Yes是

Fault resolved.故障排除。

No否

Look for causes from other symptoms.从其他症状查找原因。

Caution:注意：

♦

After replacing the integrated electric drive assembly, you need to use a diagnostic tool to recalibrate the integrated electric drive assembly.更换集成电力驱动总成后，需用诊断仪对集成电力驱动总成重新标定。