P22E411 - TroubleshootingP22E411-故障诊断

Fault code description故障码说明

DTC故障码(DTC)	Fault code description故障码描述	Possible cause of failure可能故障原因
P22E411	DCDC low voltage output short circuit level 1 faultDCDC低压输出短路1级故障	1.DCDC low voltage is too low1.DCDC低压电压太低
		1. DCDC low voltage voltage is out of control1.DCDC低压电压失控

Troubleshooting steps故障诊断步骤

①Power on check上电检查

1. Repower the vehicle, use the diagnostic tool to read and clear the fault codes, and check whether the fault codes and symptoms are eliminated.车辆重新上电，使用诊断仪读取并清除故障码，检查故障码及症状是否排除。 Are the test results normal?检查结果是否正常？ Yes是 Fault resolved.故障排除。 No否 Go to step 2.去步骤2。

②Check DCDC output voltage检查DCDC输出电压

1. The vehicle is powered on.车辆上电。 2. Use a digital multimeter to measure the voltage between the positive and negative terminals of the 12V battery.使用数字万用表测量蓄电池正、负极之间的电压。 Standard voltage value: about 14V标准电压值：约14V Are the test results normal?检查结果是否正常？ Yes是 Go to step 3.去步骤3。 No否 Check the DCDC and its lines; if normal, go to step 3.检修DCDC及其线路；若正常，去步骤3。

③Replacing the integrated electric drive assembly更换集成电力驱动总成

1. Replace the integrated electric drive assembly with a new one and check whether the fault code and symptoms are eliminated.更换新的集成电力驱动总成，检查故障码及症状是否排除。 Are the test results normal?检查结果是否正常？ Yes是 Fault resolved.故障排除。 No否 Look for causes from other symptoms.从其他症状查找原因。   Caution:注意： ♦  After replacing the integrated electric drive assembly, you need to use a diagnostic tool to recalibrate the integrated electric drive assembly.更换集成电力驱动总成后，需用诊断仪对集成电力驱动总成重新标定。