|
①General inspection一般检查
|
|
1. |
Check the right rear-facing camera wiring harness for damage, breakage, etc.检查右侧后向摄像头线束是否存在损坏、断裂等现象。
|
|
2. |
Check whether there is any loose connection or damage to the wiring harness connector.检查线束接插件是否存在虚接、损坏等现象。
|
Are the test results normal?检查结果是否正常?
|
No否 |
Repair or replace faulty wiring harness or connector.维修或更换故障线束或接插件。 |
|
|
②Power on check上电检查
|
|
1. |
Repower the vehicle, use the diagnostic tool to read and clear the fault codes, and check whether the fault codes and symptoms are eliminated.车辆重新上电,使用诊断仪读取并清除故障码,检查故障码及症状是否排除。
|
Are the test results normal?检查结果是否正常?
|
Yes是 |
Fault resolved.故障排除。 |
|
|
③Check for electromagnetic interference检查电磁干扰
|
|
1. |
Check for sources of magnetic fields around the vehicle.检查车辆周围是否存在磁场源。
|
Are the test results normal?检查结果是否正常?
|
No否 |
Move the vehicle away from its current environment.使车辆驶离当前环境。 |
|
|
④Replace the right rear-facing camera更换右侧后向摄像头
|
|
1. |
Replace the right rear-facing camera with a new one and check whether the fault code and symptoms are eliminated.更换新的右侧后向摄像头,检查故障码及症状是否排除。
|
Are the test results normal?检查结果是否正常?
|
Yes是 |
Fault resolved.故障排除。 |
|
|
⑤Replacing the autonomous driving domain controller更换自动驾驶域控制器
|
|
1. |
Replace with a new autonomous driving domain controller and check whether the fault code and symptoms are eliminated.更换新的自动驾驶域控制器,检查故障码及症状是否排除。
|
Are the test results normal?检查结果是否正常?
|
Yes是 |
Fault resolved.故障排除。 |
|
No否 |
Look for causes from other symptoms.从其他症状查找原因。 |
Caution:注意: |
|
♦
|
After replacing the autonomous driving domain controller, you need to use a diagnostic tool to recalibrate the autonomous driving domain controller.更换自动驾驶域控制器后,需用诊断仪对自动驾驶域控制器重新标定。 |
|
|