B211696 - TroubleshootingB211696-故障诊断

Fault code description故障码说明

DTC故障码(DTC)	Fault code description故障码描述	Possible cause of failure可能故障原因
B211696	There is a fault with the sensor on the right rear side of the USS, and there is an internal fault in the component.USS右后侧传感器存在故障，组件内部故障	1. The sensor harness is in poor contact or the sensor is damaged.1.传感器线束接触不良或者传感器损坏

Troubleshooting steps故障诊断步骤

①Power on check上电检查

1. Repower the vehicle, use the diagnostic tool to read and clear the fault codes, and check whether the fault codes and symptoms are eliminated.车辆重新上电，使用诊断仪读取并清除故障码，检查故障码及症状是否排除。 Are the test results normal?检查结果是否正常？ Yes是 Fault resolved.故障排除。 No否 Go to step 2.去步骤2。

②Check right rear sensor wiring harness检查右后侧传感器线束

1. Check whether the right rear sensor wiring harness is normal.检查右后侧传感器线束是否正常。 Are the test results normal?检查结果是否正常？ Yes是 Go to step 3.去步骤3。 No否 Repair or replace the right rear sensor wiring harness.维修或更换右后侧传感器线束。

③Replace right rear sensor更换右后侧传感器

1. Replace the right rear sensor with a new one and check whether the fault code and symptoms are eliminated.更换新的右后侧传感器，检查故障码及症状是否排除。 Are the test results normal?检查结果是否正常？ Yes是 Fault resolved.故障排除。 No否 Go to step 4.去步骤4。

④Replacing the autonomous driving domain controller更换自动驾驶域控制器

1. Replace with a new autonomous driving domain controller and check whether the fault code and symptoms are eliminated.更换新的自动驾驶域控制器，检查故障码及症状是否排除。 Are the test results normal?检查结果是否正常？ Yes是 Fault resolved.故障排除。 No否 Look for causes from other symptoms.从其他症状查找原因。   Caution:注意： ♦  After replacing the autonomous driving domain controller, you need to use a diagnostic tool to recalibrate the autonomous driving domain controller.更换自动驾驶域控制器后，需用诊断仪对自动驾驶域控制器重新标定。