|
|
Note:提示： |
|
♦
|
The disassembly and assembly procedures for the left and right front impact sensors are basically the same. The following content takes the left side as an example.左、右前碰传感器的拆装程序基本相同，下述内容以左侧为例进行操作。 |
|
|
Removal procedure拆卸程序
|
|
1. Preparation1. 准备工作
1 Park the vehicle on a flat road, activate the parking brake, and put the vehicle's power supply in the "OFF" state.将车辆停在平坦路面，启用驻车制动，使整车电源处于“OFF”状态。
2 Disconnect the negative terminal of the 12V battery.断开蓄电池负极。
|
|
|
2. Remove the front collision sensor2. 拆卸前碰传感器
|
|
|
1 Disconnect connector A, remove the fixing bolt ①, and remove the front collision sensor.断开接插件A，拆卸固定螺栓①，取下前碰传感器。
|
|
Recommended tools: 8mm socket推荐工具：8mm套筒 |
|
|
Caution:注意： |
|
♦
|
Disconnect the negative terminal of the 12V battery for 90 seconds before operating the airbag system.断开蓄电池负极90s后，方可对安全气囊系统进行操作。 |
|
|
|
Installation procedure安装程序
|
|
1. Install the front collision sensor1. 安装前碰传感器
|
|
|
1 Place and adjust the front collision sensor to the installation position, install and tighten the fixing bolt ①, and connect connector A.放置并调整前碰传感器到安装位置，安装固定螺栓①并紧固，连接接插件A。
|
|
Recommended tools: 8mm socket推荐工具：8mm套筒 |
|
|
Torque requirement: 8-12N·m扭矩要求：8-12N•m |
|
|
|
2. Connect the negative terminal of the 12V battery, start the vehicle, and check that the airbag indicator light in the instrument cluster should go out.2. 连接蓄电池负极，启动车辆，检查组合仪表安全气囊指示灯应熄灭
|
Front impact sensor前碰传感器
