P14A319 - TroubleshootingP14A319-故障诊断

Fault code description故障码说明

DTC故障码(DTC)	Fault code description故障码描述	Possible cause of failure可能故障原因
P14A319	Electronic lock driver overcurrent电子锁驱动过流	1. The electronic lock is damaged, the wiring harness or interface is faulty1.电子锁损坏、线束或接口故障

Troubleshooting steps故障诊断步骤

①General inspection一般检查

1. Power state is "OFF", disconnect the negative terminal of the 12V battery.电源状态“OFF”，断开蓄电池负极。 2. Check whether the low-voltage wiring harness of the charging socket is damaged or broken.检查充电插座低压线束是否存在损坏、断裂等现象。 Are the test results normal?检查结果是否正常？ Yes是 Go to step 2.去步骤2。 No否 Repair or replace the low-voltage wiring harness of the charging socket.维修或更换充电插座低压线束。

②Replace charging socket更换充电插座

1. Replace the charging socket with a new one and check whether the fault code and symptoms are eliminated.更换新的充电插座，检查故障码及症状是否排除。 Are the test results normal?检查结果是否正常？ Yes是 Fault resolved.故障排除。 No否 Go to step 3.去步骤3。

③Replace vehicle controller更换整车控制器

1. Replace the vehicle controller with a new one and check whether the fault code and symptoms are eliminated.更换新的整车控制器，检查故障码及症状是否排除。 Are the test results normal?检查结果是否正常？ Yes是 Fault resolved.故障排除。 No否 Look for causes from other symptoms.从其他症状查找原因。   Caution:注意： ♦  After replacing the vehicle controller, you need to use a diagnostic tool to recalibrate the vehicle controller.更换整车控制器后，需用诊断仪对整车控制器重新标定。