P144794 - TroubleshootingP144794-故障诊断

Fault code description故障码说明

DTC故障码(DTC)	Fault code description故障码描述	Possible cause of failure可能故障原因
P144794	Non-factory mode is turned on and automatic return to P is prohibited.非工厂模式开启禁止自动回P	1. Missing writing at factory offline inspection station1.工厂下线检测工位漏写

Troubleshooting steps故障诊断步骤

①Power on check上电检查

1. Power on the vehicle again and check whether the fault code and symptoms are eliminated.车辆重新上电，检查故障码及症状是否排除。 Are the test results normal?检查结果是否正常？ Yes是 Fault resolved.故障排除。 No否 Go to step 2.去步骤2。

②Replace vehicle controller更换整车控制器

1. Replace the vehicle controller with a new one and check whether the fault code and symptoms are eliminated.更换新的整车控制器，检查故障码及症状是否排除。 Are the test results normal?检查结果是否正常？ Yes是 Fault resolved.故障排除。 No否 Look for causes from other symptoms.从其他症状查找原因。   Caution:注意： ♦  After replacing the vehicle controller, you need to use a diagnostic tool to recalibrate the vehicle controller.更换整车控制器后，需用诊断仪对整车控制器重新标定。