Troubleshooting › Cooling system › Diagnosis
B1C6011-故障诊断 · T00610875

 B1C6011 - TroubleshootingB1C6011-故障诊断

Fault code description故障码说明
DTC故障码(DTC)
Fault code description故障码描述
Possible cause of failure可能故障原因
B1C6011
The potential feedback line of the fresh/recirculation air servo motor is short-circuited or open-circuited to ground.内外气伺服电机电位反馈线对地短路或开路
1. The potential feedback line of the fresh/recirculation air servo motor is short-circuited to the ground.1.内外气伺服电机电位反馈线对地短路
Troubleshooting steps故障诊断步骤
①General inspection一般检查
1. Power state is "OFF", disconnect the negative terminal of the 12V battery.电源状态“OFF”，断开蓄电池负极。
2. Check the circulation actuator wiring harness for damage, breakage, etc.检查循环执行器线束是否存在损坏、断裂等现象。
3. Check whether there is a loose connection or damage to the circulation actuator wiring harness connector.检查循环执行器线束接插件是否存在虚接、损坏等现象。
Are the test results normal?检查结果是否正常？
Yes是 Go to step 2.去步骤2。
No否 Repair or replace faulty wiring harness or connector.维修或更换故障线束或接插件。
②Power on check上电检查
1. Repower the vehicle, use the diagnostic tool to read and clear the fault codes, and check whether the fault codes and symptoms are eliminated.车辆重新上电，使用诊断仪读取并清除故障码，检查故障码及症状是否排除。
Are the test results normal?检查结果是否正常？
Yes是 Fault resolved.故障排除。
No否 Go to step 3.去步骤3。
③Check the cycle actuator potential feedback circuit检查循环执行器电位反馈线路
1. Check whether the cycle actuator potential feedback line is short-circuited or open-circuited to ground.检查循环执行器电位反馈线路是否对地短路或开路。
Are the test results normal?检查结果是否正常？
Yes是 Go to step 4.去步骤4。
No否 Repair or replace the cycle actuator potential feedback harness.维修或更换循环执行器电位反馈线束。
④Replace cycle actuator更换循环执行器
1. Replace the cycle actuator with a new one and check whether the fault code and symptoms are eliminated.更换新的循环执行器，检查故障码及症状是否排除。
Are the test results normal?检查结果是否正常？
Yes是 Fault resolved.故障排除。
No否 Go to step 5.去步骤5。
⑤Replacing the thermal management integrated module更换热管理集成模块
1. Replace the thermal management integrated module with a new one and check whether the fault code and symptoms are eliminated.更换新的热管理集成模块，检查故障码及症状是否排除。
Are the test results normal?检查结果是否正常？
Yes是 Fault resolved.故障排除。
No否 Look for causes from other symptoms.从其他症状查找原因。
  Caution:注意：
♦  After replacing the thermal management integrated module, you need to use a diagnostic instrument to recalibrate the thermal management integrated module.更换热管理集成模块后，需用诊断仪对热管理集成模块重新标定。