Troubleshooting › Instrument cluster/driver information system › Diagnosis
U108087-故障诊断 · T00610833

 U108087 - TroubleshootingU108087-故障诊断

Fault code description故障码说明
DTC故障码(DTC)
Fault code description故障码描述
Possible cause of failure可能故障原因
U108087
There is a communication failure with VCU (VCU) and messages are lost.与VCU（VCU）通信存在故障，报文丢失
1.VCU communication failure1.VCU通信故障
2.CAN wiring harness failure2.CAN线束故障
Troubleshooting steps故障诊断步骤
①General inspection一般检查
1. Check whether the PCAN communication harness is damaged or broken.检查PCAN通讯线束是否存在损坏、断裂等现象。
2. Check whether there is any loose connection or damage to the wiring harness connector.检查线束接插件是否存在虚接、损坏等现象。
Are the test results normal?检查结果是否正常？
Yes是 Go to step 2.去步骤2。
No否 Repair or replace the faulty communication harness.维修或更换故障通讯线束。
②Power on check上电检查
1. Repower the vehicle, use the diagnostic tool to read and clear the fault codes, and check whether the fault codes and symptoms are eliminated.车辆重新上电，使用诊断仪读取并清除故障码，检查故障码及症状是否排除。
Are the test results normal?检查结果是否正常？
Yes是 Fault resolved.故障排除。
No否 Go to step 3.去步骤3。
③Check for electromagnetic interference检查电磁干扰
1. Check for sources of magnetic fields around the vehicle.检查车辆周围是否存在磁场源。
Are the test results normal?检查结果是否正常？
Yes是 Go to step 4.去步骤4。
No否 Move the vehicle away from its current environment.使车辆驶离当前环境。
④Check VCU fault code检查VCU故障码
1. Use a diagnostic tool to read the VCU fault code and check whether there is a fault in the vehicle controller.使用诊断仪读取VCU故障码，检查整车控制器是否存在故障。
Are the test results normal?检查结果是否正常？
Yes是 Go to step 5.去步骤5。
No否 Troubleshoot vehicle controller faults based on fault codes.根据故障码排除整车控制器故障。
⑤Replace the combination switch and clock spring assembly更换组合开关与时钟弹簧总成
1. Replace the combined switch and clock spring assembly with a new one, and check whether the fault code and symptoms are eliminated.更换新的组合开关与时钟弹簧总成，检查故障码及症状是否排除。
Are the test results normal?检查结果是否正常？
Yes是 Fault resolved.故障排除。
No否 Look for causes from other symptoms.从其他症状查找原因。
  Caution:注意：
♦  After replacing the combination switch and clock spring assembly, you need to use a diagnostic instrument to recalibrate the combination switch and clock spring assembly.更换组合开关与时钟弹簧总成后，需用诊断仪对组合开关与时钟弹簧总成重新标定。