Left sun visor assembly左遮阳板总成
Removal procedure拆卸程序
|
1. Preparation1. 准备工作
1 Park the vehicle on a flat road, activate the parking brake, and put the vehicle's power supply in the "OFF" state.将车辆停在平坦路面，启用驻车制动，使整车电源处于“OFF”状态。
2 Disconnect the negative terminal of the 12V battery.断开蓄电池负极。
|
|
2. Remove the left sun visor assembly2. 拆卸左遮阳板总成
1 Lift the visor and remove one side of the visor from the visor hook.掀开遮阳板，将遮阳板一侧从遮阳板挂钩上取下。
2 Pry off the bolt trim cover.撬开螺栓饰盖。
|
 |
3 Remove the 2 fixing screws ① to remove the left sun visor assembly from the installation position.拆卸2颗固定螺钉①，使左遮阳板总成脱离安装位置。
|
 |
4 Disconnect connector A and remove the left sun visor assembly.断开接插件A，取下左遮阳板总成。
|
Installation procedure安装程序
|
1. Install the left sun visor assembly1. 安装左遮阳板总成
|
|
|
1 Connect connector A.连接接插件A。
|
|
|
2 Place and adjust the left sun visor assembly to the installation position, install 2 fixing screws ① and tighten.放置并调整左遮阳板总成到安装位置，安装2颗固定螺钉①并紧固。
3 Install the bolt trim cover.安装螺栓饰盖。
4 Install the visor onto the visor hook.安装遮阳板到遮阳板挂钩上。
|
|
2. Connect the negative terminal of the 12V battery, start the vehicle, and check that the sunshade should work normally2. 连接蓄电池负极，启动车辆，检查遮阳帘应正常工作
|