Removal procedure拆卸程序
|
|
1. Preparation1. 准备工作
1 Park the vehicle on a flat road, activate the parking brake, and put the vehicle's power supply in the "OFF" state.将车辆停在平坦路面，启用驻车制动，使整车电源处于“OFF”状态。
|
|
|
2. Remove the lower left bracket of the electric hatchback door drive part2. 拆卸电动掀背门驱动件左下支架
|
|
|
1 Pry out the liftback door gas spring circlip A, and disconnect the liftback door gas spring from the lower left bracket of the electric liftback door drive part.撬出掀背门气弹簧卡簧A，断开掀背门气弹簧与电动掀背门驱动件左下支架的连接。
|
|
Recommended tools: Slotted screwdriver推荐工具：一字螺丝刀 |
|
|
Caution:注意： |
|
♦
|
The assistant works together to prevent the hatchback door assembly from falling suddenly.助手协同操作，防止掀背门总成突然下落。 |
|
|
|
|
|
2 Remove the 2 fixing bolts ① and remove the lower left bracket of the electric hatchback door drive part.拆卸2颗固定螺栓①，取下电动掀背门驱动件左下支架。
|
|
Recommended tools: T40 socket推荐工具：T40套筒 |
|
Installation procedure安装程序
|
|
1. Install the lower left bracket of the electric liftgate drive part1. 安装电动掀背门驱动件左下支架
|
|
|
1 Place and adjust the lower left bracket of the electric hatchback door driver to the installation position, install 2 fixing bolts ① and tighten them.放置并调整电动掀背门驱动件左下支架到安装位置，安装2颗固定螺栓①并紧固。
|
|
Recommended tools: T40 socket推荐工具：T40套筒 |
|
|
Torque requirement: 27-33N·m扭矩要求：27-33N•m |
|
|
|
2 Install the hatchback door gas spring to the lower left bracket of the electric liftgate door drive part, making sure that the liftback door gas spring circlip A is installed in place.安装掀背门气弹簧到电动掀背门驱动件左下支架，确保掀背门气弹簧卡簧A安装到位。
|
|
|
2. Start the vehicle and check that the hatchback door opens and closes normally.2. 启动车辆，检查掀背门开合应正常工作
|
Electric liftgate drive unit lower left bracket电动掀背门驱动件左下支架
