Example of deep grinding and polishing process深度研磨抛光处理工艺过程示例

1.

Use 2000# water sandpaper to grind the damaged paint surface, parallel and close to the paint surface to be polished, and perform circular polishing.用2000＃水砂纸对受损漆面进行研磨处理，平行并紧贴于待磨漆面，进行圆打磨

2.

Remove surface sanding dust清除表面打磨灰

3.

Apply an appropriate amount of polishing paste to the paint surface to be polished, and adjust the polishing machine speed取适量抛光膏涂于待抛光漆面上，调整抛光机转速

4.

Put the wool ball on the paint surface and then turn it on, the speed is 2500-3000r/min将羊毛球贴上漆面后再开机，转速2500-3000r/min   Caution:注意： ♦  Keep the machine moving smoothly and gently, and avoid excessive grinding.保持机器平稳轻轻移动，切忌研磨过量。 ♦  Ensure that the grinding time is as short as possible (3~5s) and the grinding area is as small as possible.保证研磨时间尽可能短(3~5s)，研磨区域尽可能的小。

5.

First, fully wet the sponge and squeeze out the excess water; apply a small amount of glazing wax on the surface to be polished, put the sponge on the paint surface, then turn on the machine, rotate at 2500-3000r/min, and then press lightly for 3-5 seconds for glazing.先将海绵充分湿润，挤去多余水分；取少量上光蜡涂抹在待抛漆面上，将海绵贴上漆面后再开机，转速2500-3000r/min，再轻压3-5s进行上光处理   Caution:注意： ♦  Keep the machine moving smoothly and gently during operation. Do not operate for too long to avoid overheating and burning the paint surface.操作时保持机器平稳轻轻移动，切忌时间过长，以免产生过热，灼伤漆面。