|
①General inspection一般检查
|
|
1. |
Power status "OFF".电源状态“OFF”。 |
|
2. |
Check the right rear combination lamp wiring harness for damage, breakage, etc.检查右后组合灯线束是否存在损坏、断裂等现象。 |
|
3. |
Check the right rear combination lamp wiring harness connector for damage, loose connection, etc.检查右后组合灯线束接插件是否存在损坏、虚接等现象。 |
Are the test results normal?检查结果是否正常?
|
No否 |
Repair or replace faulty wiring harness or connector.维修或更换故障线束或接插件。 |
|
|
②Check the right rear turn signal A feedback harness检查右后转向灯A反馈线束
|
 |
|
1. |
Power state is "OFF", disconnect the negative terminal of the 12V battery.电源状态“OFF”,断开蓄电池负极。 |
|
2. |
Disconnect the right rear combination light harness connector BD86 and the integrated body control module harness connector BD57.断开右后组合灯线束接插件BD86和集成式车身控制模块线束接插件BD57。 |
|
3. |
Use a multimeter to measure the resistance between pin 7 of the BD57 and ground.使用万用表测量BD57的7号针脚与接地之间的电阻。 Standard resistance value: >1M标准电阻值:>1M
Ω
|
Are the test results normal?检查结果是否正常?
|
No否 |
Repair or replace the faulty wiring harness.维修或更换故障线束。 |
|
|
③Replace right rear combination light更换右后组合灯
|
|
1. |
Replace the right rear combination lamp with a new one and check whether the fault code and symptoms are eliminated.更换新的右后组合灯,检查故障码及症状是否排除。 |
Are the test results normal?检查结果是否正常?
|
Yes是 |
Fault resolved.故障排除。 |
|
|
④Replacing the integrated body control module更换集成式车身控制模块
|
|
1. |
Replace with a new integrated body control module and check whether the fault code and symptoms are eliminated.更换新的集成式车身控制模块,检查故障码及症状是否排除。
|
Are the test results normal?检查结果是否正常?
|
Yes是 |
Fault resolved.故障排除。 |
|
No否 |
Look for causes from other symptoms.从其他症状查找原因。 |
Caution:注意: |
|
♦
|
After replacing the integrated body control module, you need to use a diagnostic tool to recalibrate the integrated body control module.更换集成式车身控制模块后,需用诊断仪对集成式车身控制模块重新标定。 |
|
|