B2E9168 - TroubleshootingB2E9168-故障诊断

Fault code description故障码说明

DTC故障码(DTC)	Fault code description故障码描述	Possible cause of failure可能故障原因
B2E9168	Presence of foreign matter存在异物	1. It is detected that there is a metal block on the charging coil or excessive loss during charging.1.检测到充电线圈上有金属块存在或者是充电时损耗过大

Troubleshooting steps故障诊断步骤

①General inspection一般检查

1. Check the charging coil for metal and other metallic debris.检查充电线圈上是否存在金属及其他金属杂物。 Are the test results normal?检查结果是否正常？ Yes是 Go to step 2.去步骤2。 No否 Remove debris from the charging coil.清除充电线圈上的杂物。

②Power on check上电检查

1. Repower the vehicle, use the diagnostic tool to read and clear the fault codes, and check whether the fault codes and symptoms are eliminated.车辆重新上电，使用诊断仪读取并清除故障码，检查故障码及症状是否排除。 Are the test results normal?检查结果是否正常？ Yes是 Fault resolved.故障排除。 No否 Go to step 3.去步骤3。

③Replace the mobile phone wireless charging module更换手机无线充电模块

1. Replace with a new mobile phone wireless charging module and check whether the fault code and symptoms are eliminated.更换新的手机无线充电模块，检查故障码及症状是否排除。 Are the test results normal?检查结果是否正常？ Yes是 Fault resolved.故障排除。 No否 Look for causes from other symptoms.从其他症状查找原因。   Caution:注意： ♦  After replacing the mobile phone wireless charging module, you need to use a diagnostic tool to recalibrate the mobile phone wireless charging module.更换手机无线充电模块后，需用诊断仪对手机无线充电模块重新标定。