U013187 - TroubleshootingU013187-故障诊断

Fault code description故障码说明

DTC故障码(DTC)	Fault code description故障码描述	Possible cause of failure可能故障原因
U013187	There is a fault in communication with EPS and the message is lost.与EPS通信存在故障，报文丢失	1. Lost communication with EPS1.与EPS丢失通信

Troubleshooting steps故障诊断步骤

①Power on check上电检查

1. Repower the vehicle, use the diagnostic tool to read and clear the fault codes, and check whether the fault codes and symptoms are eliminated.车辆重新上电，使用诊断仪读取并清除故障码，检查故障码及症状是否排除。 Are the test results normal?检查结果是否正常？ Yes是 Fault resolved.故障排除。 No否 Go to step 2.去步骤2。

②General inspection一般检查

1. Power state is "OFF", disconnect the negative terminal of the 12V battery.电源状态“OFF”，断开蓄电池负极。 2. Check the ACANFD communication harness for damage, rupture, etc.检查ACANFD通讯线束是否存在损坏、破裂等现象。 3. Check the ACANFD communication harness connector for loose connections or damage.检查ACANFD通讯线束接插件是否存在虚接、损坏等现象。 Are the test results normal?检查结果是否正常？ Yes是 Go to step 3.去步骤3。 No否 Repair or replace faulty wiring harness or connector.维修或更换故障线束或接插件。

③Check the electric power steering system检查电动助力转向系统

1. Power "OFF".电源“OFF”。 2. Connect the diagnostic tool.连接诊断仪。 3. Power "ON".电源“ON”。 4. Use a diagnostic tool to check whether the electric power steering system is normal.使用诊断仪检查电动助力转向系统是否正常。 Are the test results normal?检查结果是否正常？ Yes是 Go to step 4.去步骤4。 No否 Overhaul the electric power steering system.检修电动助力转向系统。

④Replace lane departure warning ECU更换车道偏离预警ECU

1. Replace with a new lane departure warning ECU and check whether the fault code and symptoms are eliminated.更换新的车道偏离预警ECU，检查故障码及症状是否排除。 Are the test results normal?检查结果是否正常？ Yes是 Fault resolved.故障排除。 No否 Look for causes from other symptoms.从其他症状查找原因。   Caution:注意： ♦  After replacing the lane departure warning ECU, you need to use a diagnostic tool to recalibrate the lane departure warning ECU.更换车道偏离预警ECU后，需用诊断仪对车道偏离预警ECU重新标定。