Troubleshooting › Air bag system › Diagnosis
B002911-故障诊断 · T00607303

 B002911 - TroubleshootingB002911-故障诊断

Fault code description故障码说明
DTC故障码(DTC)
Fault code description故障码描述
Possible cause of failure可能故障原因
B002911
Passenger side air curtain circuit short circuit to ground乘员侧气帘回路对地短路
1. Passenger side air curtain circuit short circuit to ground1.乘员侧气帘回路对地短路
Troubleshooting steps故障诊断步骤
①General inspection一般检查
1. Power state is "OFF", disconnect the negative terminal of the 12V battery.电源状态“OFF”，断开蓄电池负极。
2. Check the right air curtain wire harness for damage, breakage, etc.检查右侧气帘线束是否存在损坏、断裂等现象。
Are the test results normal?检查结果是否正常？
Yes是 Go to step 2.去步骤2。
No否 Repair or replace the right air curtain harness.维修或更换右侧气帘线束。
②Check the wiring harness from the airbag electronic control unit to the right air curtain检查安全气囊电控单元至右侧气帘之间的线束
Graphic
1. Power state is "OFF", disconnect the negative terminal of the 12V battery.电源状态“OFF”，断开蓄电池负极。
2. Disconnect the airbag electronic control unit harness connector BD52 and the right air curtain harness connector BD97.断开安全气囊电控单元线束接插件BD52和右侧气帘线束接插件BD97。
3. Use a digital multimeter to measure the resistance between pin 21/22 of the BD52 and ground.用数字万用表测量BD52的21/22号针脚与接地之间的电阻。
Standard resistance value: >1M标准电阻值：＞1M Ω
Are the test results normal?检查结果是否正常？
Yes是 Go to step 3.去步骤3。
No否 Repair or replace the wiring harness from the airbag electronic control unit to the right curtain airbag.维修或更换安全气囊电控单元至右侧气帘之间的线束。
③Replace the right curtain air curtain更换右侧气帘
1. Replace the right air curtain with a new one and check whether the fault code and symptoms are eliminated.更换新的右侧气帘，检查故障码及症状是否排除。
Are the test results normal?检查结果是否正常？
Yes是 Fault resolved.故障排除。
No否 Go to step 4.去步骤4。
④Replace airbag electronic control unit更换安全气囊电控单元
1. Replace the airbag electronic control unit with a new one and check whether the fault code and symptoms are eliminated.更换新的安全气囊电控单元，检查故障码及症状是否排除。
Are the test results normal?检查结果是否正常？
Yes是 Fault resolved.故障排除。
No否 Look for causes from other symptoms.从其他症状查找原因。
  Caution:注意：
♦  After replacing the airbag electronic control unit, you need to use a diagnostic tool to recalibrate the airbag electronic control unit.更换安全气囊电控单元后，需用诊断仪对安全气囊电控单元重新标定。