|
①General inspection一般检查
|
|
1. |
Power state is "OFF", disconnect the negative terminal of the 12V battery.电源状态“OFF”,断开蓄电池负极。
|
|
2. |
Check the right air curtain wire harness for damage, breakage, etc.检查右侧气帘线束是否存在损坏、断裂等现象。
|
Are the test results normal?检查结果是否正常?
|
No否 |
Repair or replace the right air curtain harness.维修或更换右侧气帘线束。 |
|
|
②Check the wiring harness from the airbag electronic control unit to the right air curtain检查安全气囊电控单元至右侧气帘之间的线束
|
 |
|
1. |
Power state is "OFF", disconnect the negative terminal of the 12V battery.电源状态“OFF”,断开蓄电池负极。
|
|
2. |
Disconnect the airbag electronic control unit harness connector BD52 and the right air curtain harness connector BD97.断开安全气囊电控单元线束接插件BD52和右侧气帘线束接插件BD97。
|
|
3. |
Connect the negative terminal of the 12V battery and the power status is "ON".连接蓄电池负极,电源状态“ON”。 |
|
4. |
Use a digital multimeter to measure the voltage between pin 21/22 of the BD52 and ground.用数字万用表测量BD52的21/22号针脚与接地之间的电压。 Standard voltage value: 0V标准电压值:0V
|
Are the test results normal?检查结果是否正常?
|
No否 |
Repair or replace the wiring harness from the airbag electronic control unit to the right curtain airbag.维修或更换安全气囊电控单元至右侧气帘之间的线束。 |
|
|
③Replace the right curtain air curtain更换右侧气帘
|
|
1. |
Replace the right air curtain with a new one and check whether the fault code and symptoms are eliminated.更换新的右侧气帘,检查故障码及症状是否排除。
|
Are the test results normal?检查结果是否正常?
|
Yes是 |
Fault resolved.故障排除。 |
|
|
④Replace airbag electronic control unit更换安全气囊电控单元
|
|
1. |
Replace the airbag electronic control unit with a new one and check whether the fault code and symptoms are eliminated.更换新的安全气囊电控单元,检查故障码及症状是否排除。
|
Are the test results normal?检查结果是否正常?
|
Yes是 |
Fault resolved.故障排除。 |
|
No否 |
Look for causes from other symptoms.从其他症状查找原因。 |
Caution:注意: |
|
♦
|
After replacing the airbag electronic control unit, you need to use a diagnostic tool to recalibrate the airbag electronic control unit.更换安全气囊电控单元后,需用诊断仪对安全气囊电控单元重新标定。 |
|
|