B108001 - TroubleshootingB108001-故障诊断

Fault code description故障码说明

DTC故障码(DTC)	Fault code description故障码描述	Possible cause of failure可能故障原因
B108001	The identification code of the sensor is inconsistent with the identification code predetermined by the algorithm.传感器的识别码与算法预定的识别码不一致	1. The software is newly downloaded, but the files in the EEPROM/FlashROM have not changed, for example due to a power outage.1.新下载软件，但EEPROM/FlashROM里文件没有变更，比如由于断电
		2. The wrong parameters were flashed online2.在线刷新了错误参数

Troubleshooting steps故障诊断步骤

①Power on check上电检查

1. Repower the vehicle, use the diagnostic tool to read and clear the fault codes, and check whether the fault codes and symptoms are eliminated.车辆重新上电，使用诊断仪读取并清除故障码，检查故障码及症状是否排除。 Are the test results normal?检查结果是否正常？ Yes是 Fault resolved.故障排除。 No否 Go to step 2.去步骤2。

②Refresh data重新刷写数据

1. Use the diagnostic tool to re-flash or download complete and correct parameters.使用诊断仪重新刷写或下载完整正确参数。 Are the test results normal?检查结果是否正常？ Yes是 Fault resolved.故障排除。 No否 Go to step 3.去步骤3。

③Replace airbag electronic control unit更换安全气囊电控单元

1. Replace the airbag electronic control unit with a new one and check whether the fault code and symptoms are eliminated.更换新的安全气囊电控单元，检查故障码及症状是否排除。 Are the test results normal?检查结果是否正常？ Yes是 Fault resolved.故障排除。 No否 Look for causes from other symptoms.从其他症状查找原因。   Caution:注意： ♦  After replacing the airbag electronic control unit, you need to use a diagnostic tool to recalibrate the airbag electronic control unit.更换安全气囊电控单元后，需用诊断仪对安全气囊电控单元重新标定。