|
①General inspection一般检查
|
|
1. |
Power status is "OFF", disconnect the negative terminal of the 12V battery.电源状态“OFF”,断开蓄电池负极。
|
|
2. |
Check the air conditioning compressor assembly wiring harness for damage, breakage, etc.检查空调压缩机总成线束是否存在损坏、断裂等现象。
|
|
3. |
Check whether there is any loose connection or damage to the air conditioning compressor assembly wiring harness connector.检查空调压缩机总成线束接插件是否存在虚接、损坏等现象。
|
Are the test results normal?检查结果是否正常?
|
No否 |
Repair or replace faulty wiring harness or connector.维修或更换故障线束或接插件。 |
|
|
②Power on check上电检查
|
|
1. |
Repower the vehicle, use the diagnostic tool to read and clear the fault codes, and check whether the fault codes and symptoms are eliminated.车辆重新上电,使用诊断仪读取并清除故障码,检查故障码及症状是否排除。
|
Are the test results normal?检查结果是否正常?
|
Yes是 |
Fault resolved.故障排除。 |
|
|
③Check LIN communication waveform检查LIN通讯波形
|
|
1. |
Power status "OFF".电源状态“OFF”。
|
|
2. |
Connect the oscilloscope.连接示波器。
|
|
3. |
Power status "ON".电源状态“ON”。
|
|
4. |
Measure the LIN waveform with an oscilloscope.用示波器测量LIN波形。
|
Are the test results normal?检查结果是否正常?
|
No否 |
Check the LIN communication harness; if normal, go to step 4.检查LIN通讯线束;若正常,去步骤4。 |
|
|
④Replace air conditioning compressor assembly更换空调压缩机总成
|
|
1. |
Replace the air conditioning compressor assembly with a new one and check whether the fault code and symptoms are eliminated.更换新的空调压缩机总成,检查故障码及症状是否排除。
|
Are the test results normal?检查结果是否正常?
|
Yes是 |
Fault resolved.故障排除。 |
|
No否 |
Look for causes from other symptoms.从其他症状查找原因。 |
|