DC charging

Page 160

NOTE (Cont'd)

◆ It is suggested that an GAC Brand charging pile should be used for Charging Reservation, as other charging piles available in the market might not support Charging Reservation.

◆ If you need to charge the vehicle immediately when the charging mode is Charging Reservation you should change the charging model to "Instant Charging", otherwise Instant Charging will not be available. Reservations after charging is completed will not be affected. Reservations before charging will be canceled automatically (if a reservation is repeated, only the reservation for the current day will be canceled). ◆ The charging thermal protection function can be activated on the center console display to maintain the battery temperature, improve the battery range and vehicle performance while driving, and prolong the service life of the traction battery. In the case of AC charging in a low-temperature environment, the charging thermal protection function will be activated automatically. ◆ You can enable or disable the thermal protection through the center console display.

◆ If other AC charging piles on the market are used, the charging thermal protection function may not work properly. It is recommended to use GAC Brand’s dedicated charging pile or home power supply to charge the vehicle. ◆ If you encounter special

circumstances and cannot unlock the charger, you can unlock it through the emergency unlocking device of the charger. For details, please refer to the "Emergency treatment - Owner emergency -Emergency unlocking/ locking" section.

DC charging

1. Unlock the vehicle, press the rear edge of the charging inlet cap to open it.

2. Open the DC charging inlet dust cover.

Page 161

3. Connect the charger. After the charger is successfully connected, all turn signal lamps will become yellow and on for a long time, and the charger indicator lamp on the instrument panel comes on.

IC

ca

rd

4. Make relevant settings on the charging pile (such as scanning QR code or swiping a card), and start the charging pile.

5. Check the charging status through the instrument cluster.

6. You can actively stop the charging as desired, or the charging can be stopped automatically when the vehicle is fully charged.

7. Pull out the charger.

8. Close the charging inlet dust cover and the charging inlet cap, and insert the charger back into the charging pile to complete the charging.

WARNING

◆ During the charging, make sure that the vehicle is properly connected to the power supply, and it is forbidden to unplug the charger.

◆ After the DC charging, please unplug the charger in time.

NOTE

◆ The above-mentioned DC charging method of the charging station is a general method, which may be slightly different from the charging method indicated on the actual charging pile. Please follow the indications of the charging pile during actual charging.