Correct installation of child safety seat (non-Europe)
Text of these pages
Page 40
Correct installation of child safety seat (non- Europe)
Install child seat using seat belt
The steps to install a child seat using a seat belt are as follows:
1.
Adjust the front seats to the forefront and adjust the seat back to a vertical angle.
2.
Place the child seat on the rear seat.
5.
6.
1.
2.
3.
Pull out the seat belt, go through the child seat in the proper direction, insert the seat belt lock tongue into the belt buckle, confirm the locking, and make sure the seat belt is not twisted.
3.
4.
Use your body to press down the child seat placed on the seat, reel the seat belt and tighten it to ensure that it does not slack.
4.
Try pushing and pulling the child seat in different directions to make sure it is installed firmly.
Reset and adjust the front seats.
Install child seat using the ISOFIX anchorage
The steps to install a child seat using the ISOFIX anchorage are as follows:
Adjust the front seats to the forefront and adjust the seat back to a vertical angle.
Pull back the anchorage cover between the back and the seat cushion. Place the child seat on the rear seat.
Secure the locking mechanism of the lower part of the child seat ① correctly to the ISOFIX anchorage of the rear seat ②.
Page 41
Try pushing and pulling the child seat in different directions to make sure it is installed firmly.
5.
6.
Reset and adjust the front seats.
WARNING
When using the ISOFIX anchorage, make sure there are no foreign objects around the ISOFIX anchorage and the seat belt is not stuck behind the anchorage.
If the total weight of a child plus an ISOFIX exceeds 33 kg, do not use ISOFIX anchors with a child restraint system or a combination booster seat.
Please follow the installation instructions and precautions included with the child seat you purchased.
NOTE:
During the actual installation of the child safety seat, be sure to refer to the owner's manual for the child safety seat for correct installation. When installing a child seat, if the anchorage cover between the back and the seat cushion affects the installation of the i- Size interface, the anchorage cover can be stowed into the gap between the back and the seat cushion. Ensure child seat back is flat to the vehicle seat. If vehicle head restraint prevents this, the head restraint can be raised or removed.
For a large child seat, if the installation is difficult, consider moving the front seats forward or backward, or adjusting the angle of the front seat back.
If the rear seat headrest interferes with the installation of a child seat, the rear seat headrest can be raised or removed, to limit or prevent interference. Ensure child seat back is flat to